Spread your tile adhesive and lay the tile. Place LEV TEC clips underneath the tile slightly back from the edge. Keep the LEV TEC clip firmly against the tile as the clip acts as a 1.5mm spacer.
Set the adjacent tile firmly into the adhesive. Butt the tile against the LEV TEC clip giving the 1.5mm joint (if a larger joint is required spacers can be used, or set the required joint size). Slide the LEV TEC wedges (Sold Separately) through the LEV TEC clips until they are firmly levelling both tiles.
Using your thumb push the LEV TEC wedge with the right amount of pressure required to create the perfect finish. Once the tiles are locked in position this is how they will stay until the adhesive sets. You can still slightly adjust the joint width while the adhesive is setting without disrupting the height of the tiles.
After the adhesive has set, you can remove the LEV TEC wedges and clips easily with a rubber mallet on the walls and by mallet or your foot on the floor. Hit the LEV TEC clips on its side lug in the direction of the tile joint and the wedge and clip will dislodge from the tile at the breakpoint below the tile, leaving the joint free for grouting or silicone expansion.
_edited_edited_edited.png)
