.png)
Kelmore Repair Mortar 11kg
Kelmore Repair Mortar is a moisture tolerant, ultra-rapid setting and drying mortar. Suitable for horizontal and vertical applications and able to be applied from 2mm to 50mm, this non-slumping mortar can be used for interior and exterior applications. Kelmore Repair Mortar can be used to repair, fill and patch backgrounds, as well as to form ramps, falls, and coves, and being moisture tolerant, it can be used below damp proof membranes. This ultra-rapid drying product can be covered with levelling and smoothing compound after 45 minutes, tiled with porcelain, ceramic, and natural stone tiles after 60 minutes and resilient floor coverings can be fitted after 90 minutes.
Product
Kelmore Repair Mortar
Product info
Classification
CT-C30-F6Pack Size
11kgAreas of use
Walls, Floors, Horizontal Applications, Vertical Applications, Interior, Exterior, Domestic, Commercial, Below Damp Proof Membranes, Heated Screeds
Suitable Backgrounds
Cement: Sand Screed (inc heated), Concrete, Cement: Sand Render, Concrete Blockwork - No Primer Required
Pre-cast Concrete - PrimeMore Grip - Prime with one neat, undiluted coat of PrimeMore Grip. Allow the primer to dry before applying Kelmore Repair Mortar.
Coverage
Coverage will vary dependent on the texture of the background and the application thickness of the product. As a guide, an 11kg bag of Kelmore Repair Mortar will provide the following approximate coverage:
Application
ThicknessApproximate
Coverage2mm 3.46m2 5mm 1.38m2 10mm 0.69m2 25mm 0.28m2 50mm 0.14m2 Preparation
Backgrounds must be sufficiently dry and strong enough to carry the total weight being applied. All surfaces must be clean, sound and free from contaminants that could inhibit adhesion, such as dust, dirt, oil, grease, laitance, and curing agents.
Mixing
An 11kg bag of Kelmore Repair Mortar should be mixed with approximately 2.1 litres of clean, cold water. If mixing smaller batches, the mixing ratio by volume is approximately 3½ parts powder to 1 part water. Pour the water into a clean bucket before gradually adding the powder. Mix thoroughly until a smooth, slump-free consistency is achieved.
Mix in the ratio 3½ : 1
(3½ parts powder to 1 part water)Application
Kelmore Repair Mortar can be applied from 2mm to 50mm. Apply the mortar to the wall or floor using a steel trowel ensuring sufficient pressure is applied so the mortar keys into the background. Where required, the mortar can be left proud, and on firming, the excess can be trimmed off (mortar will firm after approximately 15 to 20 minutes at 20ºC). Once firm, the mortar can be finished with a wet trowel to smooth and enhance the surface finish if required.
Application Temperature
≥ 5°CApplication Thickness
2mm to 50mmTiming
At 20°C
Working Time - 15 minutes
Hard set - 30 minutes
Apply levelling and smoothing compounds after - 45 minutes
Tile after - 60 minutes
Fit resilient floor coverings after - 90 minutes