Classification 
CT-C16-F10

Pack Size 
20kg bag  & 4.5L bottle

Floors, Interior, Domestic, Commercial, Over Adhesive Residues, Below Damp Proof Membranes, Water Piped Underfloor Heating, Electric Underfloor Heating, Limited Movement/vibration

Asphalt (Flooring Grade), Existing Ceramic, Porcelain and Natural Stone Tiles, Plywood Overlay (Class 3), Tile Backer Boards. - No Primer Required. 

Cement: Sand Screed ( inc heated), Concrete -Use PrimeMore Universal - Although priming is not necessary for the compound to bond to these porus backgrounds, priming is recommended to regulate background porosity and will result in improved adhesion, workability and the product's surface finish. 

Epoxy DPM - Use PrimeMore Grip - Kelmore DPM does not require priming if applying LevelMore Absolute 30 within 24 hours of application.

Metal(Steel) -  Use PrimeMore Grip 

Calcium Sulphate / Anhydrite Screed (inc heated) - Use PrimeMore CS 

Coverage will vary dependent on the texture of the background and the application thickness of the product. As a guide, a 20kg bag of LevelMore Absolute 30 powder mixed with 4.5 litres of LevelMore Absolute 30 liquid will provide the following approximate coverage:
 

Backgrounds must be sufficiently dry and strong enough to carry the total weight being applied. All surfaces must be clean, sound and free from contaminants that could inhibit adhesion, such as dust, dirt, oil, grease, laitance, and curing agents. Timber bases must be adequately ventilated and able to carry the additional static and dynamic load without deflection. Ensure any remaining adhesive residues are hard, sound, well adhered and not softened by water.

LevelMore Absolute 30 is a 2 part product, LevelMore Absolute 30 powder must only be mixed with LevelMore Absolute 30 liquid at a ratio of 20kg powder to 4.5 litres of liquid.

Pour the LevelMore Absolute 30 liquid into a clean bucket. Gradually add the powder whilst mixing thoroughly with an electric paddle mixer until a smooth, lump-free consistency is achieved. The compound is ready for use immediately after mixing.

LevelMore Absolute 30 can be applied at a thickness of 2mm to 20mm in a single application. Pour the mixed compound onto the prepared floor before using a trowel or rake to regulate the thickness and guide the product into the desired areas. Whilst the product is still wet, the use of a *spiked roller can further enhance the surface finish by removing any trapped air.

*The use of a spiked roller is only recommended when the product has been applied at a thickness that will allow the roller to freely roll through the compound.

Application Temperature 
≥ 5˚C

Application Thickness
Minimum - 2mm
Maximum - 20mm

At 20˚C

Working Time - 15 minutes
Walk on - 30 minutes
Tile after - 45 minutes
Fit resilient floor coverings after - 90 minutes

Drying times will vary dependent on the porosity of the background, ambient temperature and humidity. When tested to the industry standard temperature of 20°C, LevelMore Absolute 30 can be walked on after 30 minutes. Resilient floor coverings can be fitted after 90 minutes and porcelain, ceramic, and natural stone tiles can be fixed after 45 minutes. Please be aware that higher temperatures and low humidity will shorten the drying time and lower temperatures and high humidity will extend the drying time.