Kelmore Feather

Classification
CT-C16-F6

Pack Size 
11kg 

Floor, Interior, Domestic, Commercial, Heated screeds, limited movment/vibration

Cement: sand screed (inc heated), Concrete, Existing ceramic, porcelain, and natural stone tiles, Levelling and smoothing compounds, Plywood overlay (class 3) - No primer required

Calcium Sulphate / Anhydrite screed (inc heated) - PrimeMore CS Required - Prime with one neat, undiluted coat of PrimeMore CS. The primer must be allowed to dry before applying kelmore feather. 

Coverage will vary dependent on the texture of the background and the application thickness of the product. As a guide, an 11kg bag of Kelmore Feather will provide the following approximate coverage:

Backgrounds must be sufficiently dry and strong enough to carry the total weight being applied. All surfaces must be clean, sound and free from contaminants that could inhibit adhesion, such as dust, dirt, oil, grease, laitance, and curing agents.

Kelmore Feather should be mixed by volume at a ratio of approximately 3 parts powder to 1 part clean, cold water. The amount of water used in the initial mixing can be adjusted slightly to obtain the optimum consistency for the specific application. Pour the water into a clean bucket before gradually adding the powder. Mix thoroughly until a smooth, creamy consistency is achieved.

Kelmore Feather can be used from a feather edge up to 3mm thick. Apply the mixed product to the floor before using a steel trowel to smooth and fill the background.

Application Temperature 
≥ 5˚C

Application Thickness
Feather edge to 3mm

Working time - 10 minutes

Walk on time - 15 minutes

Fitting floor coverings - When Kelmore Feather has set sufficiently to be walked on, floor coverings can be installed. Depending on the application thickness and porosity of the background this can be after just 15 minutes.